These Flexible Impeller pumps are made of high quality bronze of maximum corrosion resistance. All shafts consist of stainless steel grade 303. Top of the line models have ball bearings and mechanical seals while others have bronze or carbon bearings and lip type seals. Impellers are made of Neoprene Rubber. Nitrile impellers are available as an option. Flexible blades on the periphery of the impeller provide the pumping action. While the impeller rotates the liquid between the blades is continuously squeezed out into the discharge port by a machined in cam located inside the pump chamber.
This pump model is available as a pedestal style-bare shaft, clutch driven or SAE flange mount.
Note, the direction of the shaft rotation will determine inlet and outlet ports.
Pump will operate satisfactorily when mounted in any position. DO NOT RUN DRY. Rubber impellers generate high rubbing friction unless lubricated by liquid pumped and lack of liquid will cause impeller to burn up.
Mechanical Carbon Ring, Ceramic Face Main Pump Seal
Two Sealed Ball Bearings Spaced for Maximum Load Ability
Large Vent & Drain Openings Separate Seal & Bearing Areas
Shaft Slinger for Additional Bearing Protection
Neoprene (05) or Nitrile (06) Impellers
Stainless Steel Shaft
O-Ring Seal Between Body & Cover
Impeller easily replaced
Option: Flanged Engine Mount SAE ‘B’ Available
Either direct drive with flexible coupling or pulley drive can be used. Make sure both flexible coupling halves are properly aligned. When using pulley, do not over-tighten belt.
LIQUIDS & TEMPERATURES
DO NOT PUMP SEVERE SOLVENTS OR ACIDS.
Liquids compatible with neoprene (05) can be pumped, including fresh and saltwater solutions and mild chemicals. Nitrile (06) impellers can handle oil-contaminated water. When possible, flush pump with fresh water after each usage.
Extremes of cold and heat will affect impeller life. Limits of 40°F to 180°F should be observed. Do not allow liquid in pump to freeze. Drain pump by loosening cover screws and use methyl alcohol based anti-freeze compounds such as Zerex®, Shell Zone®, Pyro Permanent®, Permagard®, or Dowgard®.
Suction lift of 15 feet is possible when impeller is wet. Suction lines must be air tight in order for pump to self-prime. A foot valve at the beginning of the suction line is recommended.
Oberdorfer is part of Gardner Denver, Inc., a leading global manufacturer of highly engineered products. Gardner Denver is headquartered in Milwaukee, Wisconsin, USA and has facilities in more than 30 countries.